Speed: The CAT Rate you set up for Menu 31 in Step 1a above. Port: Your Enhanced COM Port from step 3 above. The specific version that I am currently using is On the HRD Connect Screen set the following: a. Next turn on the FT-991 and start Ham Radio Deluxe (HRD) is started on your computer. The FT-991 will always need to be connected to the same USB connector on the computer or you must reinstall the USB Driver. I have found that connecting through a USB Hub does not work for the Hubs I have so I connect directly to the computer. Ensure your USB cable is now connected between the FT-991 and computer. The level for the mic is typically set at 70. Set the control panel sound so that USB Audio CODEC is the default. In the diagram below, I show the 2 ports and it is import to know which COM port both the Enhanced K9EQ-FUSION-PDF-0020_HRD-FT-991 Rev Apr-2016 of 8Ģ and Standard are using. It will install 2 drivers in Ports for and Enhanced COM Port and a Standard COM Port. Go to the Files section for the FT-991 on Yaesu and install the USB driver following those directions. Do not have a USB Cable connected between your FT-991 and computer. These instructions assume you re planning on using PSK-31. You will find other pages in the online manual for other digital modes. APSK Setup using DATA (PSK) Operation (). Set Menu 33, CAT RTS to Enable which is the default 2. Set Menu 32, CAT TOT to 10 which is the default c. Set Menu 31, CAT Rate to a rate you prefer. Note that I am using the online manual at and not the older one that came with my FT-991. CAT Setup using the FT-991 Operating Manual ().

Written by: KE0BRZ, Dale Christopherson 1. 1 Ham Radio Deluxe on the FT-991 DO NOT COPY AND POST THIS DOCUMENT TO ANOTHER SITE.

Ham radio deluxe setup